Armourcoat Surface Finishes
Armourcoat Ltd
Morewood Close Sevenoaks Kent TN13 2HU
T: +44(0)1732 460 668 F: +44(0)1732 450 930
UK Company 1997888.
CITB Reg No: 3054641. UTR 5287000511

Armourcoat Building Specification Sheet BSS8790

Document Generated: 2021-01-28 08:04:01
Product TypePolished Plaster
Product RefKN 8790
Product DescriptionA natural mineral material composed of lime, crushed marble and cement combined with special additives to control working characteristics.
ManufacturerArmourcoat Ltd Unit 2-3a Morewood Close Sevenoaks Kent TN13 2HU UK
Manufacturer Telephone(+44) (0)1732 460 668
Product Location*


Colour ReferencesRGB ≅ #CBCAC6         
LAB ≅ 81.44,-0.05,2.11
Light Reflectance Value ≅ 59.270
PreparationSubstrate to be prepared in accordance with Armourcoat Ltd’s guidance:
  • SSS1: Plasterboard/Drylining Installation and Finishing
  • SSS2: Plasterboard/Drylining with Armourcoat AntiCrack Skimcoat
  • SSS3: Brick, Block and Concrete
  • SSS4: Glasroc and GRG
  • SSS5: Previously Decorated
  • SSS6: Sand / Cement Render
  • SSS7: MDF
  • SSS9: Bluclad Board
  • SSS10: Exterior Application
PrimerFor surfaces with uneven suction apply Armourcoat K40 Primer
Thickness0.50 - 2.50mm Please contact Armourcoat for further details
Day JointsPlease contact Armourcoat for further details
TemperatureProducts to be applied in temperatures 10 degrees Celsius and rising, n/e 30 degrees Celsius unless through consultation with manufacturer.
Guarantee10 year guarantee for internal use. The current warranty document can be found at
Genuine ArmourcoatThe system is to be supplied and where specified, applied by Armourcoat Ltd. No substitutes within the system are supported or allowed.
Primary ComponentP700 Armural

Technical Information for P700 Armural
BSISO 11890 2 VOC Test (g/l)0.0000
Recycled Content Pctg55.0000
Shore D Hardness Test75.0000
Natural Mineral Content Percentage95.8000
Reaction to fireA2 - s1, d0

Armourcoat products contain hand applied, natural mineral contents subject to pattern and tonal variation over and above those shown on samples. Product formulations may have changed since tests were conducted.

Base product test data to ASTM and BS standards not including substrate properties.

Whilst every attempt has been made to ensure the accuracy and reliability of the information contained in this document, the information should not be relied upon as a substitute for formal advice. Armourcoat Ltd, its employees and agents will not be liable for any loss or damage, of any kind, arising out of or in connection with the use of this document. Please refer to the company disclaimer for further details.