Armourcoat Surface Finishes
Armourcoat Ltd
Morewood Close Sevenoaks Kent TN13 2HU
T: +44(0)1732 460 668 F: +44(0)1732 450 930
UK Company 1997888.
CITB Reg No: 3054641. UTR 5287000511

Armourcoat Building Specification Sheet BSS5163

Document Generated: 2021-01-28 07:38:14
Product TypePolished Plaster
Product RefAM P50 R0513 (Armuralia AM P50 R0513)
Product DescriptionA natural mineral material composed of lime, crushed marble and cement combined with special additives to control working characteristics.
ManufacturerArmourcoat Ltd Unit 2-3a Morewood Close Sevenoaks Kent TN13 2HU UK
Manufacturer Telephone(+44) (0)1732 460 668
Product Location*


Colour ReferencesRGB ≅ #6B4D55         
LAB ≅ 36.32,13.11,0.03
Light Reflectance Value ≅ 9.175
PreparationSubstrate to be prepared in accordance with Armourcoat Ltd’s guidance:
  • SSS1: Plasterboard/Drylining Installation and Finishing
  • SSS2: Plasterboard/Drylining with Armourcoat AntiCrack Skimcoat
  • SSS3: Brick, Block and Concrete
  • SSS4: Glasroc and GRG
  • SSS5: Previously Decorated
  • SSS6: Sand / Cement Render
  • SSS7: MDF
  • SSS9: Bluclad Board
  • SSS10: Exterior Application
PrimerFor surfaces with uneven suction apply Armourcoat K40 Primer
KeycoatApply Armourcoat Keycoat K124 or K149
Day JointsUnless an expansion joint is advised by the substrate installer or structural engineer, the maximum area before the need for a day joint is 35 m2
TemperatureProducts to be applied in temperatures 10 degrees Celsius and rising, n/e 30 degrees Celsius unless through consultation with manufacturer.
Guarantee10 year guarantee for internal use. The current warranty document can be found at
Genuine ArmourcoatThe system is to be supplied and where specified, applied by Armourcoat Ltd. No substitutes within the system are supported or allowed.
Primary ComponentP50 Armuralia

Technical Information for P50 Armuralia
ASTM D3960 VOC Test (g/l)22.0000
BSISO 11890 2 VOC Test (g/l)13.0000
Recycled Content Pctg54.9300
Shore D Hardness Test67.0000
ASTM D3274 Mould & Mildew Resistance Test10/10/10
French VOC LabelA+
Reaction to fireA2 - s1, d0
ASTM E84-14 Fire Test ResultA

Armourcoat products contain hand applied, natural mineral contents subject to pattern and tonal variation over and above those shown on samples. Product formulations may have changed since tests were conducted.

Base product test data to ASTM and BS standards not including substrate properties.

Whilst every attempt has been made to ensure the accuracy and reliability of the information contained in this document, the information should not be relied upon as a substitute for formal advice. Armourcoat Ltd, its employees and agents will not be liable for any loss or damage, of any kind, arising out of or in connection with the use of this document. Please refer to the company disclaimer for further details.