Armourcoat Surface Finishes
Armourcoat Ltd
Morewood Close Sevenoaks Kent TN13 2HU
T: +44(0)1732 460 668 F: +44(0)1732 450 930
UK Company 1997888.
CITB Reg No: 3054641. UTR 5287000511

Armourcoat Building Specification Sheet BSS10147

Document Generated: 2019-01-17 22:15:36
Product TypeArmourColor
Product RefTT 10147
Product DescriptionDecorative, water-based wall coatings offering seamless, hard wearing design alternatives to vinyl and wallpaper.
ManufacturerArmourcoat Ltd Unit 2-3a Morewood Close Sevenoaks Kent TN13 2HU UK
Manufacturer Telephone(+44) (0)1732 460 668
Product Location*


PreparationCoating will follow contour of substrate. Surfaces must be:
  • 1: sound and true with no hollows or bumps
  • 2: free of curing compounds, dust, and other impurities such as oil, grease and salts
  • 3: sealed with manufacturer’s recommended primer
  • 4: cleared of all fixtures and fittings
  • 5: within background tolerance ± 1mm in 600mm and ± 3mm in 1800mm
PrimerApply 1 or more coats of ArmourColor BaseColor Matt and allow to dry.
ApplicationApply 2 coats of pre-mixed ArmourColor Perlata and finish as required. Apply ArmourColor Clearseal Gloss a minimum of 4-8 hours later (recommended in heavy traffic and vulnerable locations to improve abrasion resistance).
Thickness0.10 - 0.30mm Please contact Armourcoat for further details
Day JointsPlease contact Armourcoat for further details
TemperatureProducts to be applied in temperatures 10 degrees Celsius and rising, n/e 30 degrees Celsius unless through consultation with manufacturer.
Guarantee10 year guarantee for internal use. The current warranty document can be found at
Genuine ArmourcoatThe system is to be supplied and where specified, applied by Armourcoat Ltd. No substitutes within the system are supported or allowed.
Primary ComponentTT Tactite

Technical Information for TT Tactite
ASTM D3960 VOC Test (g/l)67.0000
ASTM D6886-03 VOC Test (g/l)10.00
BSISO 11890 2 VOC Test (g/l)3.2000
JIS A 1901 VOC Test (micrograms/m2/h)1.00
ASTM E84-03 Fire Test ResultA

Armourcoat products contain hand applied, natural mineral contents subject to pattern and tonal variation over and above those shown on samples. Product formulations may have changed since tests were conducted.

Base product test data to ASTM and BS standards not including substrate properties.

Whilst every attempt has been made to ensure the accuracy and reliability of the information contained in this document, the information should not be relied upon as a substitute for formal advice. Armourcoat Ltd, its employees and agents will not be liable for any loss or damage, of any kind, arising out of or in connection with the use of this document. Please refer to the company disclaimer for further details.